今天閑來上網，偶見一博友發布的這篇文章，雖簡短，但很有見地，所以將此干貨呈現于此，讓更多搞袋式除塵器設計的同僚更上一層樓
1.Design your system to accommodate the full range of operating conditions
袋式除塵器的設計必須滿足系統滿負荷的運行條件
2.Design your system to evenly distribute the gas and dust to all areas of the baghouse and never store dust for long periods in the hoppers.
設計時必須充考慮到含塵煙氣是否能夠均勻地進入袋式除塵器內的各部分；決不能將除塵器灰斗用于儲灰
3.Incorporate fabric that is compatible with the full range of inlet conditions and outlet requirements
整臺袋式除塵器不但要能適應進入除塵器的煙氣條件，而且要使出口煙氣達到環保排放標準
4.Make sure the system is compatible with your plant’s O&M procedures and requirements
要保證除塵器系統的運行能滿足您工廠實際運行和維護的規程及要求
5.Inspect all system components thoroughly before installation and again prior to initial start-up for compliance to specifications and for correct assembly
安裝或設備啟動前，必須徹底檢查所有的除塵器組件是否已滿足說明書要求并正確安裝
6.Develop start-up and shutdown procedures to protect your bag site and abide by them
建立正確的除塵器啟動和停機程序，以防止濾袋的不必要損壞
7.Establish and maintain the required bag cleaning energy and frequency to stabilize system pressure-drop without over cleaning
確立并維持濾袋清灰所要求的能量和頻率，在設備清灰不過分的情況下實現系統壓降的穩定
8.Monitor and maintain historical records of key system parameters on a regular basis to assess system stability
定期監測和評估系統的穩定性，并將系統運行的主要參數保留存檔
9.Identify and solve problems early, before they snowball
盡可能早地發現和解決問題，千萬不要延誤解決問題的時機
10.When in doubt---go to a lower G/C ratio
在懷疑或沒有把握的情況下，選擇較低的氣布比（過濾速度）不會錯！
